C613-50631-01 Rev A Command Reference for IE340 Series 3154
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
NTP COMMANDS
SHOW
NTP STATUS
show ntp status
Overview Use this command to display the status of the Network Time Protocol (NTP).
Syntax
show ntp status
Mode User Exec and Privileged Exec
Example To see information about NTP status, use the command:
awplus# show ntp status
For information about the output displayed by this command, see ntp.org.
Figure 60-3: Example output from show ntp status
awplus#show ntp status
Reference ID : C0A8010A (192.168.1.10)
Stratum : 4
Ref time (UTC) : Fri Jun 15 05:32:38 2018
System time : 0.000002004 seconds fast of NTP time
Last offset : -0.002578615 seconds
RMS offset : 0.000928071 seconds
Frequency : 5.099 ppm slow
Residual freq : -9.120 ppm
Skew : 17.486 ppm
Precision : -21 (0.000000477 seconds)
Root delay : 0.031749818 seconds
Root dispersion : 0.133974627 seconds
Update interval : 65.3 seconds
Leap status : Normal
To Next Page
Loading...
