52
C613-50631-01 Rev A Command Reference for IE340 Series 2603
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OpenFlow
Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
the OpenFlow protocol.
Command List •“openflow” on page 2604
•“openflow controller” on page 2605
•“openflow datapath-id” on page 2607
•“openflow failmode” on page 2608
•“openflow inactivity” on page 2610
•“openflow native vlan” on page 2611
•“openflow ssl peer certificate” on page 2612
•“openflow ssl trustpoint” on page 2613
•“openflow version” on page 2614
•“show openflow config” on page 2615
•“show openflow coverage” on page 2617
•“show openflow flows” on page 2619
•“show openflow rules” on page 2622
•“show openflow ssl” on page 2624
•“show openflow status” on page 2625
To Next Page
Loading...
Need help?
General
