C613-50631-01 Rev A Command Reference for IE340 Series 1753
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MULTICAST COMMANDS
DEBUG
NSM MCAST
debug nsm mcast
Overview Use this command to debug IPv4 events in the Multicast Routing Information Base
(MRIB).
This command is intended for use by Allied Telesis authorized service personnel
for diagnostic purposes.
Syntax
debug nsm mcast
{all|fib-msg|mrt|mtrace|mtrace-detail|register|stats|vif}
Mode Privileged Exec and Global Configuration
Examples To enable debugging of all multicast route events, use the commands:
awplus# configure terminal
awplus(config)# debug nsm mcast all
To enable debugging of PIM register entries, use the commands:
awplus# configure terminal
awplus(config)# debug nsm mcast register
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
Parameter Description
all All IPv4 multicast debugging.
fib-msg Forwarding Information Base (FIB) messages.
mrt Multicast routes.
mtrace Multicast traceroute.
mtrace-detail Multicast traceroute detailed debugging.
register Multicast PIM register messages.
stats Multicast statistics.
vif Multicast interface.
To Next Page
Loading...
Need help?
General
