C613-50631-01 Rev A Command Reference for IE340 Series 1354
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
BGP
SCAN-TIME (BGP ONLY)
bgp scan-time (BGP only)
Overview Use this command to set the interval for BGP route next-hop scanning.
Use the no variant of this command to disable this function.
Syntax
bgp scan-time <time>
no bgp scan-time [<time>]
Default The default scanning interval is 60 seconds.
Mode Router Configuration
Usage Use this command to configure scanning intervals of BGP routers. This interval is
the period after which router checks the validity of the routes in its database.
To disable BGP scanning, set the scan time interval to 0 seconds.
Example
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# bgp scan-time 10
Command
changes
Added to AlliedWare Plus prior to 5.4.6-1
Version 5.4.7-2.1: BGP support added for x510 and x550 series
Version 5.4.7-2.4: BGP support added for IE300 series
Parameter Description
<time> <0-60> Scanning interval in seconds.
To Next Page
Loading...
Need help?
General
