C613-50631-01 Rev A Command Reference for IE340 Series 2825
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
DOMAIN VLAN
atmf domain vlan
Overview The AMF domain VLAN is created when the AMF network is first initiated and is
assigned a default VID of 4091. This command enables you to change the VID from
this default value on this device.
The AMF domain VLAN is one of AMF’s internal VLANs (the management VLAN is
the other internal VLAN). AMF uses these internal VLANs to communicate network
status information between nodes. These VLANs must be reserved for AMF and not
used for other purposes.
An important point conceptually is that although the domain VLAN exists globally
across the AMF network, it is assigned separately to each domain. The AMF
network therefore can be thought of as comprising a series of domain VLANs each
having the same VID and each being applied to a horizontal slice (domain) of the
AMF. It follows therefore that the domain VLANs are only applied to ports that form
cross-links and not to ports that form uplinks/downlinks.
CAUTION: Every member of your AMF network must have the same domain VLAN,
management VLAN, and management subnet.
CAUTION: If you change the domain VLAN, management VLAN, or management
subnet of a node, that change takes effect immediately and the node will immediately
leave the AMF network and try to rejoin it. The AMF network will not be complete until
you have given all devices the same setting, so they can all rejoin the AMF network.
Use the no variant of this command to reset the VLAN ID to its default value of
4091.
Syntax
atmf domain vlan <2-4090>
no atmf domain vlan
Default VLAN 4091
Mode Global Configuration
Usage notes We recommend you only change the domain VLAN when first creating the AMF
network, and only if VLAN 4091 is already being used in your network.
Parameter Description
<2-4090> The VLAN number in the range 2 to 4090.
To Next Page
Loading...
Need help?
General
