33
C613-50631-01 Rev A Command Reference for IE340 Series 1710
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MLD and MLD
Snooping
Commands
Introduction
Overview This chapter provides an alphabetical reference of configuration, clear, and show
commands related to MLD and MLD Snooping.
The Multicast Listener Discovery (MLD) module includes the MLD Proxy service and
MLD Snooping functionality. Some of the following commands may have
commonalities and restrictions; these are described under the Usage section for
each command.
MLD and MLD Snooping commands only apply to switch ports, not Ethernet
interfaces.
Before using PIM-SMv6:
• IPv6 must be enabled on an interface (ipv6 enable),
• IPv6 forwarding must be enabled globally for routing IPv6 (ipv6 forwarding),
and
• IPv6 multicasting must be enabled globally (ipv6 multicast-routing).
Command List •“clear ipv6 mld” on page 1712
•“clear ipv6 mld group” on page 1713
•“clear ipv6 mld interface” on page 1714
•“debug mld” on page 1715
•“ipv6 mld” on page 1716
•“ipv6 mld access-group” on page 1717
•“ipv6 mld immediate-leave” on page 1718
•“ipv6 mld last-member-query-count” on page 1719
•“ipv6 mld last-member-query-interval” on page 1720
•“ipv6 mld limit” on page 1721
•“ipv6 mld querier-timeout” on page 1723
To Next Page
Loading...
Need help?
General
