Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 318
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM INTERRUPTS
show system interrupts
Overview Use this command to display the number of interrupts for each IRQ (Interrupt
Request) used to interrupt input lines on a PIC (Programmable Interrupt Controller)
on your device.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show system interrupts
Mode User Exec and Privileged Exec
Example To display information about the number of interrupts for each IRQ in your device,
use the command:
awplus# show system interrupts
Output Figure 7-22: Example output from the show system interrupts command
Related
commands
show system environment
awplus>show system interrupts
CPU0
1: 2 CPM2 SIU Level Enabled 0 i2c-mpc
2: 145 CPM2 SIU Level Enabled 0 spi-mpc
77: 0 OpenPIC Level Enabled 0 enet_tx
78: 2 OpenPIC Level Enabled 0 enet_rx
82: 0 OpenPIC Level Enabled 0 enet_error
90: 5849 OpenPIC Level Enabled 0 serial
91: 2066672 OpenPIC Level Enabled 0 i2c-mpc
94: 147 OpenPIC Level Enabled 0 cpm2_cascade
112: 5 OpenPIC Edge Enabled 0 phy_interrupt
114: 398714 OpenPIC Level Enabled 0 mvPP
115: 26247 OpenPIC Level Enabled 0 mvPP
119: 0 OpenPIC Edge Enabled 0 Power supply status
...
BAD: 0

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English