Allied Telesis IE340 Series - ip pim dense-mode wrong-vif-suppression

C613-50631-01 Rev A Command Reference for IE340 Series 1919
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-DM COMMANDS
IP
PIM DENSE-MODE WRONG-VIF-SUPPRESSION
ip pim dense-mode wrong-vif-suppression
Overview Use this command to permit or block packets that arrive on the wrong VLAN
Interface (VIF) for PIM dense-mode.
Use the no variant of this command to disable dense-mode wrong VIF suppression
Syntax
ip pim dense-mode wrong-vif-suppression
no ip pim dense-mode wrong-vif-suppression
Default Disabled.
Mode Global Configuration
Usage notes This command enables wrong VIF suppression for PIM dense-mode. Wrong VIF
suppression prevents multicast packets received on the wrong upstream interface
from being copied to the CPU.
Examples To enable wrong VIF suppression, use the commands:
awplus# configure terminal
awplus(config)# ip pim dense-mode wrong-vif-suppression
To disable wrong VIF suppression, use the commands:
awplus# configure terminal
awplus(config)# no ip pim dense-mode wrong-vif-suppression
Command
changes
Version 5.4.8-2.3: command added.