Allied Telesis IE340 Series - show ip ospf interface

C613-50631-01 Rev A Command Reference for IE340 Series 1194
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
SHOW
IP OSPF INTERFACE
show ip ospf interface
Overview Use this command to display interface information for OSPF.
For information on filtering and saving command output, see the “Getting_Started
with AlliedWare Plus” Feature Overview and Configuration_Guide.
Syntax
show ip ospf interface [<interface-list>]
Mode User Exec and Privileged Exec
Examples
awplus# show ip ospf interface vlan2
Output Figure 28-17: Example output from the show ip ospf interface command
Parameter Description
<interface-list> The interfaces to display information about. An interface-list
can be:
•a VLAN (e.g. vlan2)
• the loopback interface (lo)
• a continuous range of interfaces separated by a hyphen
(e.g. vlan10-20)
• a comma-separated list (e.g. vlan1,vlan10-20). Do not mix
interface types in a list.
awplus#show ip ospf interface
vlan2 is up, line protocol is up
Internet Address 1.1.1.1/24, Area 0.0.0.0, MTU 1500
Process ID 0, Router ID 33.33.33.33, Network Type BROADCAST, Cost: 10
Transmit Delay is 1 sec, State Waiting, Priority 1, TE Metric 0
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Neighbor Count is 0, Adjacent neighbor count is 0
Crypt Sequence Number is 1106347721
Hello received 0 sent 1, DD received 0 sent 0
LS-Req received 0 sent 0, LS-Upd received 0 sent 0
LS-Ack received 0 sent 0, Discarded 0