Allied Telesis IE340 Series - Route Map Commands; Introduction

31
C613-50631-01 Rev A Command Reference for IE340 Series 1602
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Route Map
Commands
Introduction
Overview This chapter provides an alphabetical reference for route map commands. For
more information, see the Routemaps Feature Overview and Configuration Guide.
These commands can be divided into the following categories:
•the route-map command, which is used to create a route map and/or route
map entry, and to put you into route map mode
• match commands, used to determine which routes or BGP update messages
the route map applies to
• set commands, used to modify matching routes or BGP update messages
Command List •“match as-path” on page 1604
•“match community” on page 1606
•“match interface” on page 1608
•“match ip address” on page 1609
•“match ip next-hop” on page 1611
•“match ipv6 address” on page 1613
•“match ipv6 next-hop” on page 1615
•“match metric” on page 1616
•“match origin” on page 1617
•“match route-type” on page 1619
•“match tag” on page 1620
•“route-map” on page 1621
•“set aggregator” on page 1624
•“set as-path” on page 1625
•“set atomic-aggregate” on page 1626