C613-50631-01 Rev A Command Reference for IE340 Series 1936
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-DM COMMANDS
SHOW
IP PIM DENSE-MODE NEXTHOP
show ip pim dense-mode nexthop
Overview This command displays the next hop information as used by PIM-DM. In the
context of PIM-DM, the term ‘ next hop’ refers to the next hop router on the path
back to the source address of a multicast stream.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip pim dense-mode nexthop
Mode User Exec and Privileged Exec
Example
awplus# show ip pim dense-mode nexthop
Output Figure 37-8: Example output from the show ip pim dense-mode neighbor
nexthop command
Destination Nexthop Nexthop Nexthop Metric Pref
Num Addr Interface
192.168.10.52 1 0.0.0.0 vlan2 3 1
Table 2: Parameters in the output of the show ip pim dense-mode neighbor
nexthop command
Parameter Description
Destination Destination address for which PIM-DM requires next hop
information.
Nexthop Num Number of next hops to the destination. PIM can only use
one next hop.
Nexthop Addr Address of the current next hop gateway.
Nexthop Interface Name of the next hop interface.
Metric Metric of the route towards the destination.
Preference Preference of the route towards the destination.
To Next Page
Loading...
Need help?
General
