Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 1839
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
SHOW
IP PIM SPARSE-MODE NEXTHOP
show ip pim sparse-mode nexthop
Overview Use this command to see the next hop information as used by PIM-SM.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide
Syntax
show ip pim sparse-mode nexthop
Mode User Exec and Privileged Exec
Example
awplus# show ip pim sparse-mode nexthop
Figure 35-15: Example output from the show ip pim sparse-mode nexthop
command
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
Flags: N = New, R = RP, S = Source, U = Unreachable 
Destination Type Nexthop Nexthop Nexthop Nexthop Metric Pref Refcnt
Num Addr Ifindex Name 
____________________________________________________________________________
10.10.0.9 .RS. 1 0.0.0.0 4 0 0 1 
Table 2: Parameters in output of the show ip pim sparse-mode nexthop
command
Parameter Description
Destination The destination address for which PIM-SM requires next hop
information.
Type The type of destination, as indicated by the Flags description. N =
New, R= RP, S = Source, U = Unreachable.
Nexthop Num The number of next hops to the destination. PIM-SM always uses
only 1 next hop.
Nexthop Addr The address of the primary next hop gateway.
Nexthop
IfIndex
The interface on which the next hop gateway can be reached.
Nexthop Name The name of next hop interface.
Metric The metric of the route towards the destination.
Preference The preference of the route towards destination.
Refcnt Only used for debugging.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English