Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 1265
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPFV3 FOR IPV6 COMMANDS
REDISTRIBUTE
(IPV6 OSPF)
redistribute (IPv6 OSPF)
Overview Use this command to redistribute routes from other routing protocols, static
routes and connected routes into an IPv6 OSPF routing table.
Use the no variant of this command to disable this function.
Syntax
redistribute <protocol>} [metric <0-16777214>] [metric-type
{1|2}] [route-map <route-map-entry>]
no redistribute <protocol>
Default The default metric value for routes redistributed into OSPFv3 is 20. The metric can
also be defined using the set metric command for a route map. Note that a metric
defined using the set metric command for a route map overrides a metric defined
with this command.
Mode Router Configuration
Usage notes You use this command to inject routes, learned from other routing protocols, into
the OSPF domain to generate AS-external-LSAs. If a route-map is configured by
this command, then that route-map is used to control which routes are
redistributed and can set metric and tag values on particular routes.
The metric, metric-type, and tag values specified on this command are applied to
any redistributed routes that are not explicitly given a different metric,
metric-type, or tag value by the route map.
See the OSPFv3 Feature Overview and Configuration Guide for more information
about metrics, and about behavior when configured in route maps.
Note that this command does not redistribute the default route. To redistribute the
default route, use the default-information originate command.
Parameter Description
<protocol> The routing protocol to be redistributed, can be one of:
connected Connected routes
rip Routing Internet Protocol
static Static Routes
metric Specifies the external metric.
metric-type Specifies the external metric-type, either type 1 or type 2.
• For Metric Type 1: The best route is based on the external
redistributed path cost plus the internal path cost presented by
the native routing protocol.
• For Metric Type 2: The best route is based only on the external
redistributed path cost. The internal path cost is only used to break
a “tie” situation between two identical external path costs.
route-map The name of the specific route-map.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English