To Next Page

To Previous Page

C613-50631-01 Rev A Command Reference for IE340 Series 3020

AlliedWare Plus™ Operating System - Version 5.5.3-0.x

AMF AND AMF PLUS COMMANDS

STATE

state

Overview This command sets the running state of an AMF container on a Virtual AMF

Appliance (VAA).

An AMF container is an isolated instance of AlliedWare Plus with its own network

interfaces, configuration, and file system. The features available inside an AMF

container are a sub-set of the features available on the host VAA. These features

enable the AMF container to function as a uniquely identifiable AMF master and

allows for multiple tenants (up to 60) to run on a single VAA host. See the

AMF Feature Overview and Configuration Guide for more information on running

multiple tenants on a single VAA host.

Syntax

state {enable|disable}

Default By default, state is disabled.

Mode AMF Container Configuration

Usage notes The first time the state enable command is executed on a container it assigns the

container to an area and configures it as an AMF master. This is achieved by

automatically adding the following configuration to the AMF container:

For this reason the state enable command should be run after the container has

been created with the atmf container command and an area-link configured with

the area-link command.

Once the start-up configuration has been saved from within the AMF container, all

further configuration changes need to be made manually.

Parameter Description

disable Stop the AMF container. The container’s state changes to

stopped.

enable Start the AMF container. The container’s state changes to

running.

atmf network-name <AMF network-name>

atmf master

atmf area <container area-name> <container area-id> local

atmf area <container area-name> password <container area-password>

atmf area <host area-name> <host area-id>



interface eth0

atmf-arealink remote-area <host area-name> vlan 4094

Allied Telesis IE340 Series User Manual

Other manuals for Allied Telesis IE340 Series