C613-50631-01 Rev A Command Reference for IE340 Series 2106
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV6 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
VTY
IPV6 ACCESS-CLASS (NAMED)
vty ipv6 access-class (named)
Overview For IPv6, use this command to set a standard named software access list to be the
management ACL. This is then applied to all available VTY lines for controlling
remote access by Telnet and SSH. This command allows or denies packets
containing the IPv6 addresses included in the ACL to create a connection to your
device.
ACLs that are attached using this command have an implicit ‘deny-all’ filter as the
final entry in the ACL. A typical configuration is to permit a specific address, or
range of addresses, and rely on the ‘deny-all’ filter to block all other access.
Use the no variant of this command to remove the access list.
Syntax
vty ipv6 access-class <access-name>
no vty ipv6 access-class [<access-name>]
Mode Global Configuration
Examples To set the named standard access-list named access-ctrl to be the IPv6
management ACL, use the following commands:
awplus# configure terminal
awplus(config)# vty ipv6 access-class access-ctrl
To remove access-ctrl from the management ACL, use the following commands:
awplus# configure terminal
awplus(config)# no vty ipv6 access-class access-ctrl
Output Figure 41-3: Example output from the show running-config command
Related
commands
show running-config
vty access-class (numbered)
Parameter Description
<access-name> Specify an IPv6 standard software access-list name
awplus#show running-config|grep access-class
vty ipv6 access-class access-ctrl
To Next Page
Loading...
Need help?
General
