C613-50631-01 Rev A Command Reference for IE340 Series 3169
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
MAC
ADDRESS-TABLE NOTIFICATION MAC-CHANGE INTERVAL
mac address-table notification mac-change
interval
Overview Use this command to set the maximum time that a MAC change SNMP notification
is delayed in the MAC address table.
Use the no variant of this command to set the interval back to the default (1).
Syntax
mac address-table notification mac-change interval
<0-2147483647>
no mac address-table notification mac-change interval
Default Interval is set at 1 second.
Mode Global Configuration
Usage notes If the mac-change history table is not enabled, then the interval is stored for when
it is enabled.
To enable the mac-change history table, use the command:
• mac address-table notification mac-change
Example To configure an interval of 5 seconds for the time between two MAC change SNMP
notifications being sent, use the commands:
awplus# configure terminal
awplus(config)# mac address-table notification mac-change
interval 5
Related
commands
clear mac address-table notification mac-change
mac address-table notification mac-change
mac address-table notification mac-change history-size
mac address-table notification mac-threshold
show mac address-table notification mac-change
snmp trap mac-change
Command
changes
Version 5.5.1-2.1: command added
Parameter Description
<0-2147483647> Set the interval in seconds.
To Next Page
Loading...
Need help?
General
