C613-50631-01 Rev A Command Reference for IE340 Series 2839
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
MASTER
atmf master
Overview This command configures the device to be an AMF master node and automatically
creates an AMF master group. The master node is considered to be the core of the
AMF network, and must be present for the AMF to form. The AMF master has its
node depth set to 0. Note that the node depth vertical distance is determined by
the number of uplinks/downlinks that exist between the node and its master.
An AMF master node must be present for an AMF network to form. Up to two AMF
master nodes may exist in a network, and they must be connected by an AMF
crosslink.
NOTE: Master nodes are an essential component of an AMF network. In order to run
AMF, an AMF License is required for each master node.
If the crosslink between two AMF masters fails, then one of the masters will
become isolated from the rest of the AMF network.
Use the no variant of this command to remove the device as an AMF master node.
The node will retain its node depth of 0 until the network is rebooted.
NOTE: Node depth is the vertical distance (or level) from the master node (whose depth
value is 0).
Syntax
atmf master
no atmf master
Default The device is not configured to be an AMF master node.
Mode Global Configuration
Example To specify that this node is an AMF master, use the following command:
node-1# configure terminal
node-1(config)# atmf master
Related
commands
show atmf
show atmf group
To Next Page
Loading...
Need help?
General
