C613-50631-01 Rev A Command Reference for IE340 Series 1702
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IGMP AND IGMP SNOOPING COMMANDS
SHOW
IP IGMP PROXY GROUPS
show ip igmp proxy groups
Overview Use this command to display multicast groups with receivers directly connected to
the router, learned through IGMP, which use a proxy service. You can also use a
filter to specify a multicast group IP address and /or interface.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip igmp proxy groups [detail]
show ip igmp proxy groups <multicast-group> [detail]
show ip igmp proxy groups <vlan> [detail]
show ip igmp proxy groups <vlan> <multicast-group> [detail]
Mode User Exec
Example To display local membership information for IGMP proxy service interfaces, use the
command:
awplus# show ip igmp proxy groups
Output Figure 32-5: Example output from show ip igmp proxy groups
Example To display local membership information for IGMP proxy service interfaces, use the
command:
awplus# show ip igmp proxy groups detail
Parameter Description
groups Specify IGMP proxy group membership information.
detail Specify detailed IGMPv3 source information.
<vlan> Specify the name of a single VLAN interface, for example vlan1.
<multicast-
group>
Specify the IPv4 address in of the multicast group, in the format
A.B.C.D.
awplus#show ip igmp proxy groups
IGMP Connected Proxy Group Membership
Group Address Interface Member state
224.9.10.11 vlan10 Delay
To Next Page
Loading...
