C613-50631-01 Rev A Command Reference for IE340 Series 2921
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
LOG
EVENT-HOST
log event-host
Overview Use this command to set up an external host to log AMF topology events through
Vista Manager. This command is run on the Master device.
Use the no variant of this command to disable log events through Vista Manager.
Syntax
log event-host [<ipv4-addr>|<ipv6-addr>] atmf-topology-event
no log event-host [<ipv4-addr>|<ipv6-addr>] atmf-topology-event
Default Log events are disabled by default.
Mode Global Configuration
Usage notes Event hosts are set so syslog sends the messages out as they come.
Note that there is a difference between log event and log host messages:
• Log event messages are sent out as they come by syslog
• Log host messages are set to wait for a number of messages (20) to send
them out together for traffic optimization.
Example To enable Node 1 to log event messages from host IP address 192.0.2.31, use the
following commands:
Node1# configure terminal
Node1(config)# log event-host 192.0.2.31 atmf-topology-event
To disable Node 1 to log event messages from host IP address 192.0.2.31, use the
following commands:
Node1# configure terminal
Node1(config)# no log event-host 192.0.2.31 atmf-topology-event
Related
commands
atmf topology-gui enable
Parameter Description
<ipv4-addr> ipv4 address of the event host
<ipv6-addr> ipv6 address of the event host
To Next Page
Loading...
Need help?
General
