C613-50631-01 Rev A Command Reference for IE340 Series 1344
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
BGP
LOG-NEIGHBOR-CHANGES
bgp log-neighbor-changes
Overview Use this command to enable logging of status change messages without turning
on debug bgp commands.
Use the no variant of this command to disable this feature.
Syntax
bgp log-neighbor-changes
no bgp log-neighbor-changes
Default Disabled
Mode Router Configuration
Usage notes AlliedWare Plus™ provides other kinds of logging services for neighbor status, for
example, debug bgp fsm and debug bgp events.
However, these commands create a significant hit in the logging performance. If
you need to log neighbor status changes only, we recommend turning off all the
debug commands, and then use this command.
To see BGP neighbor changes in the log you must also set the log level to
informational using the log buffered command.
A sample output of this log is:
A sample output of the log for an interface down event is:
The bgp log-neighbor-changes command logs the following events:
• BGP Notification Received
• Erroneous BGP Update Received
• User reset request
• Peer time-out
• Peer Closing down the session
•Interface flap
•Router ID changed
•Neighbor deleted
• Member added to peer group
• Administrative shutdown
%Protocol-Severity-Events: Message-textď€
%BGP-5-ADJCHANGE: neighbor 10.10.0.24 Down Interface flapď€
To Next Page
Loading...
Need help?
General
