C613-50631-01 Rev A Command Reference for IE340 Series 2604
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OPENFLOW COMMANDS
OPENFLOW
openflow
Overview Use this command to specify a port or static aggregator as a data plane port. The
ingress and egress traffic on the data plane port become controlled by the
OpenFlow Controller. A data plane port number is assigned to the port
automatically.
Use the no variant of this command to cancel the setting of a port as a data plane
port.
Syntax
openflow
no openflow
Default All the ports are non-data plane ports by default.
Mode Interface mode for a switch port (e.g. port1.0.1) or static aggregator (e.g. sa1)
Example To specify port1.0.1 as a data plane port:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# openflow
Related
commands
show openflow config
Command
changes
Version 5.4.6-1.1: command added
Version 5.4.7-1.1: command added to GS900MX, XS900MX, x550 series products
Version 5.4.7-2.1: command added to IE300, IE500 series products
Version 5.4.8-0.2: added to SBx908 GEN2
Version 5.4.8-1.1: added to IE210L series products
To Next Page
Loading...
Need help?
General
