Allied Telesis IE340 Series - show ethernet cfm details

C613-50631-01 Rev A Command Reference for IE340 Series 379
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
CONNECTIVITY FAULT MANAGEMENT COMMANDS
SHOW
ETHERNET CFM DETAILS
show ethernet cfm details
Overview Use this command to show CFM configuration, status, and statistics in detail for all
CFM entities that the system knows about.
Syntax
show ethernet cfm details
Mode User Exec/Privileged Exec
Example To show CFM configuration, status, and statistics in detail for all CFM entities, use
the command:
awplus# show ethernet cfm details
The output loops through the hierarchy of MDs, then MAs within each MD, then
local MEPs within that MA, and finally remote MEPs within that MA.
Output Figure 9-1: Example output from show ethernet cfm details
awplus#show ethernet cfm details

==========================================================
Maintenance Domain
==========================================================
Maintenance Domain Name........... MD-INST1
Maintenance Domain Name Format.... character-string
Maintenance Domain Name Value..... MD-12L3
Level............................. 3
Associated CFM Services........... (VLAN 400 ): MA-INST1-1
(VLAN 300 ): MA-INST1-2
MIP Creation...................... None
Service
-------
CFM Service Name.................. MA-INST1-1
CFM Domain Name................... MD-INST1
CFM Domain Level.................. 3
Primary VLAN...................... 400
Maintenance Assoc Name Format..... string
Maintenance Assoc Name Value...... MA-12V400
CCM Transmission Interval......... 1 second
Local MEPs........................ MEP DOWN
2 (interface port1.0.3)
Configured Remote MEPs............ 102
Missing Remote MEPs............... None
Current MEP Defects............... -
MIP Creation...................... None