C613-50631-01 Rev A Command Reference for IE340 Series 1343
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
BGP
GRACEFUL-RESTART GRACEFUL-RESET
bgp graceful-restart graceful-reset
Overview This command enables BGP and BGP4+ graceful-restart when a configuration
change forces a peer restart.
Use the no variant of this command to restore the device to its default state.
Syntax
bgp graceful-restart graceful-reset
no bgp graceful-restart graceful-reset
Default Disabled
Mode Router Configuration
Usage The bgp graceful-restart command must be enabled before this command is
enabled. All events that cause BGP peer reset, including all session reset
commands, can trigger graceful-restart.
Example To enable the graceful-restart graceful-reset feature on the BGP or BGP4+ peer
belonging to Autonomous System (AS) 10, use the commands:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# bgp graceful-restart graceful-reset
To disable the graceful-restart graceful-reset feature on the BGP or BGP4+ peer
belonging to Autonomous System (AS) 10, use the commands:
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# no bgp graceful-restart graceful-reset
Related
commands
bgp graceful-restart
Command
changes
Added to AlliedWare Plus prior to 5.4.6-1
Version 5.4.7-2.1: BGP support added for x510 and x550 series
Version 5.4.7-2.4: BGP support added for IE300 series
To Next Page
Loading...
Need help?
General
