C613-50631-01 Rev A Command Reference for IE340 Series 1825
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM SSM
ip pim ssm
Overview Use this command to define the Source Specific Multicast (SSM) range of IP
multicast addresses. The default keyword defines the SSM range as 232/8.
To define the SSM range to be other than the default, use the access-list parameter
option.
Use the no variant of this command to disable the SSM range.
Syntax
ip pim ssm default
ip pim ssm range {<access-list>|<named-access-list>}
no ip pim ssm
Default By default, the command is disabled.
Mode Global Configuration
Usage When an SSM range of IP multicast addresses is defined by this command, the no
(*,G) or (S,G,rpt) state will be initiated for groups in the SSM range.
The messages corresponding to these states will not be accepted or originated in
the SSM range.
Examples To configure the SSM service for the IP address range defined by access list 10, use
the commands:
awplus# configure terminal
awplus(config)# access-list 10 permit 225.1.1.1
awplus(config)# ip pim ssm range 10
To use the default address range for PIM-SSM, use the commands:
awplus# configure terminal
awplus(config)# ip pim ssm default
To disable PIM-SSM, use the commands:
awplus# configure terminal
awplus(config)# no ip pim ssm
Parameter Description
default Use 232/8 as the range for SSM.
<access-list> <1-99> Simple access-list.
<named-access-list> Named Standard Access List.
To Next Page
Loading...
Need help?
General
