32
C613-50631-01 Rev A Command Reference for IE340 Series 1646
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IGMP and IGMP
Snooping
Commands
Introduction
Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection, IGMP Snooping and IGMP Proxy.
Command List •“clear ip igmp” on page 1648
•“clear ip igmp group” on page 1649
•“clear ip igmp interface” on page 1650
•“debug igmp” on page 1651
•“ip igmp” on page 1652
•“ip igmp access-group” on page 1653
•“ip igmp flood-group” on page 1654
•“ip igmp flood specific-query” on page 1656
•“ip igmp immediate-leave” on page 1657
•“ip igmp last-member-query-count” on page 1658
•“ip igmp last-member-query-interval” on page 1659
•“ip igmp limit” on page 1660
•“ip igmp maximum-groups” on page 1661
•“ip igmp mroute-proxy” on page 1663
•“ip igmp proxy-service” on page 1664
•“ip igmp querier-timeout” on page 1666
To Next Page
Loading...
Need help?
General
