C613-50631-01 Rev A Command Reference for IE340 Series 1624
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTE MAP COMMANDS
SET
AGGREGATOR
set aggregator
Overview Use this command to add an aggregator set clause to a route map entry.
When a BGP update message matches the route map entry, the device sets the
update’s aggregator attribute. The aggregator attribute specifies the AS and IP
address of the device that performed the aggregation.
Use the no variant of this command to remove the set clause.
Syntax
set aggregator as <asnum> <ip-address>
no set aggregator as
Mode Route-map Configuration
Usage An Autonomous System (AS) is a collection of networks under a common
administration sharing a common routing strategy. It is subdivided by areas, and is
assigned a unique 16- bit number. Use the set aggregator command to assign an
AS number for the aggregator.
This command is valid for BGP update messages only.
Example To use entry 3 of the route map called myroute to set the aggregator attribute to
43 10.10.0.3 in matching update messages, use the commands:
awplus# configure terminal
awplus(config)# route-map myroute permit 3
awplus(config-route-map)# set aggregator as 43 10.10.0.3
To remove all aggregator attributes for entry 3 of the route map called myroute,
use the commands:
awplus# configure terminal
awplus(config)# route-map myroute permit 3
awplus(config-route-map)# no set aggregator as
Related
commands
route-map
show route-map
Parameter Description
<asnum> The AS number of the aggregator.
<ip-address> The IP address of the aggregator.
To Next Page
Loading...
Need help?
General
