Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2969
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF GUESTS
show atmf guests
Overview This command is available on any AMF master or controller in the network. It
displays a summary of the AMF guest nodes that exist in the AMF network,
including device type, parent node, and IP address.
Syntax
show atmf guests
Mode User Exec/Privileged Exec
Usage notes Use this command to display all guest nodes in a network. If you want to see only
the guests attached to a single node, use the show atmf links guest command,
which shows information about the guest nodes and also about their link to their
parent node.
Example To display the AMF guest output, use the command:
awplus# show atmf guests
Output Figure 57-24: Example output from the show atmf guests command
master#show atmf guests

Guest Information:

Device Device Parent Guest IP/IPv6
Name Type Node Port Address
---------------------------------------------------------------------
node1-2.0.1 x600-24Ts node1 2.0.1 192.168.2.10
wireless-zone1 AT-TQ4600 node2 1.0.1 192.168.1.10
wireless-zone2 AT-TQ4600 node2 1.0.2 192.168.1.12

Current ATMF guest node count 3
Table 63: Parameters shown in the output of the show atmf guests command
Parameter Description
Device Name The name that is discovered from the device, or failing
that, a name that is auto-assigned by AMF. The
auto-assigned name consists of:
<parent node name>-<attached port number>
You can change this by configuring a description on the
port.
Device Type The product name of the guest node, which is discovered
from the device. If no device type can be discovered, this
shows the name of the AMF guest-class that has been
assigned to the guest node by the atmf guest-class
command.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English