Allied Telesis IE340 Series - show snmp-server trap

C613-50631-01 Rev A Command Reference for IE340 Series 3183
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SHOW
SNMP-SERVER TRAP
show snmp-server trap
Overview Use this command to display the status of the SNMP traps.
Syntax
show snmp-server trap
Mode Privileged Exec
Example To display the SNMP traps status, use the commands:
awplus# show snmp-server trap
Output Figure 62-8: Example output from show snmp-server trap
Related
commands
show snmp-server
snmp-server enable trap
awplus#show snmp-server trap
ATMF traps ........................... Disabled
ATMF Link traps ...................... Disabled
ATMF Node traps ...................... Disabled
ATMF Guest Node traps ................ Enabled
ATMF Reboot Rolling traps ............ Disabled
Authentication failure ............... Disabled
BGP traps ............................ Disabled
CWM Access Point traps ............... Enabled
DHCP Snooping traps .................. Disabled
EPSR traps ........................... Disabled
LLDP traps ........................... Disabled
Loop Protection traps ................ Disabled
MSTP traps ........................... Disabled
NSM traps ............................ Disabled
OSPF traps ........................... Disabled
PIM traps ............................ Disabled
Power-inline traps ................... Disabled
QoS Storm Protection traps ........... Enabled
RMON traps ........................... Disabled
MAC address Thrash Limiting traps .... Disabled
UDLD traps ........................... Disabled
VCS traps ............................ Disabled
VRRP traps ........................... Disabled
Wireless traps ....................... Disabled