C613-50631-01 Rev A Command Reference for IE340 Series 2943
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF AREA GUESTS-DETAIL
Related
commands
show atmf area nodes-detail
show atmf area guests
Table 67: Parameters shown in the output of the show atmf guest detail
command
Parameter Description
Node Name The name of the guest’s parent node.
Port Name The port on the parent node that connects to the guest.
IFindex An internal index number that maps to the port number
on the parent node.
Guest Description A brief description of the guest node as manually entered
into the description (interface) command for the guest
node port on the parent node.
Device Type The device type as supplied by the guest node itself.
Backup Supported Indicates whether AMF supports backup of this guest
node.
MAC Address The MAC address of the guest node.
IP Address The IP address of the guest node.
IPv6 Address The IPv6 address of the guest node.
HTTP Port The HTTP port enables you to specify a port when
enabling http to allow a URL for the http user interface of
a Guest Node. This is determined by the http-enable
command.
Firmware Version The firmware version that the guest node is currently
running.
To Next Page
Loading...
Need help?
General
