C613-50631-01 Rev A Command Reference for IE340 Series 2962
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF CONTAINER
Related
commands
area-link
atmf area
atmf area password
atmf container
atmf container login
bridge-group (amf-container)
description (amf-container)
state
Command
changes
Version 5.4.7-0.1: command added
PID Internal container id.
IP This lists the IP addresses used by the container. These include
the eth1 IP address and the AMF management IP address.
CPU use The CPU usage of the container since it was enabled.
Memory use Container memory usage.
Link Each container has two links:
1 An AMF area-link, this connects the container to the AMF
controller and uses virtual interface eth0 on the AMF
container.
2 A bridged L2 network link, this connects the container to
the outside world and uses the virtual interface eth1 on the
AMF container.
See the AMF Feature Overview and Configuration_Guide for
more information on these links.
TX/RX bytes Bytes sent and received on a link.
Total bytes Total bytes transferred on a link.
Table 57-3: Parameters in the output from show atmf container detail (cont.)
Parameter Description
To Next Page
Loading...
