Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2972
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF GUESTS DETAIL
Node Name : node1
Port Name : port1.0.13
Ifindex : 5013
Guest Description : node1-1.0.13
Device Type : AT-TQ4600
Backup Supported : Yes
MAC Address : eccd.6df2.daa0
IP Address : 192.168.5.6
IPv6 Address : Not Set
HTTP Port : 80
Firmware Version : 3.1.0 B01
Table 64: Parameters in the output from show atmf guests detail.
Parameter Description
Node Name The name of the parent node, which is the AMF node that
directly connects to the guest node.
Port Name The port on the parent node that connects to the guest.
IfIndex An internal index number that maps to the port number
on the parent node.
Guest Description A description that is discovered from the device, or failing
that, auto-assigned by AMF. The auto-assigned name
consists of: 
<parent node name>-<attached port number>. 
You can change this by configuring a description on the
port.
Device Type The product name of the guest node, which is discovered
from the device. If no device type can be discovered, this
shows the name of the AMF guest-class that has been
assigned to the guest node by the atmf guest-class
command.
Username The user name configured on the guest node.
Backup Supported Whether the guest node supports AMF backup
functionality.
MAC Address The MAC address of the guest node.
IP Address The IP address of the guest node.
IPv6 Address The IPv6 address of the guest node.
Firmware Version The version of the firmware operating on the guest node.
HTTP port The HTTP port as specified with the http-enable
command when defining a guest class. You can set this if
the guest node provides an HTTP user interface on a
non-standard port (any port other than port 80).

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English