C613-50631-01 Rev A Command Reference for IE340 Series 138
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
Valid characters The filename and path can include characters from up to four categories. The
categories are:
1) uppercase letters: A to Z
2) lowercase letters: a to z
3) digits: 0 to 9
4) special symbols: most printable ASCII characters not included in the previous
three categories, including the following characters:
•-
•/
•.
•_
•@
•"
•'
•*
•:
•~
•?
Do not use spaces, parentheses or the + symbol within filenames. Use hyphens or
underscores instead.
Syntax for
directory listings
A leading slash (/) indicates the root of the current file system location.
In commands where you need to specify the local file system’s flash base directory,
you may use flash or flash: or flash:/. For example, these commands are all the
same:
• dir flash
• dir flash:
• dir flash:/
Similarly, you can specify the USB storage device base directory with usb or usb:
or usb:/
You cannot name a directory or subdirectory flash, nvs, usb, card, tftp, scp, sftp
or http. These keywords are reserved for tab completion when using various file
commands.
Command List •“autoboot enable” on page 141
•“boot config-file” on page 142
•“boot config-file backup” on page 144
•“boot system” on page 145
To Next Page
Loading...
Need help?
General
