Allied Telesis IE340 Series - Page 1514

C613-50631-01 Rev A Command Reference for IE340 Series 1514
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
UPDATE-SOURCE
Examples [BGP] To source BGP connections for neighbor 10.10.0.72 with the IP address of the local
loopback address instead of the best local address, enter the commands listed
below:
awplus(config)# interface lo
awplus(config-if)# ip address 10.10.0.73/24
awplus(config-if)# exit
awplus(config)# router bgp 100
awplus(config-router)# network 10.10.0.0
awplus(config-router)# neighbor 10.10.0.72 remote-as 110
awplus(config-router)# neighbor 10.10.0.72 update-source lo
To remove BGP connections for neighbor 10.10.0.72 with the IP address of the local
loopback address instead of the best local address, enter the commands listed
below:
awplus(config)# router bgp 100
awplus(config-router)# no neighbor 10.10.0.72 update-source
To source BGP connections for neighbor group1 with the IP address of the local
loopback address instead of the best local address, enter the commands listed
below:
awplus(config)# interface lo
awplus(config-if)# ip address 10.10.0.73/24
awplus(config-if)# exit
awplus(config)# router bgp 100
awplus(config-router)# network 10.10.0.0
awplus(config-router)# neighbor group1 peer-group
awplus(config-router)# neighbor 10.10.0.72 remote-as 100
awplus(config-router)# neighbor 10.10.0.72 peer-group group1
awplus(config-router)# neighbor group1 update-source lo
To remove BGP connections for neighbor group1 with the IP address of the local
loopback address instead of the best local address, enter the commands listed
below:
awplus(config)# router bgp 100
awplus(config-router)# neighbor group1 update-source lo