C613-50631-01 Rev A Command Reference for IE340 Series 1655
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP FLOOD-GROUP
To configure an IGMP flooding group to Layer 2 ports and Layer 3 forwarding, use
the following commands. This will flood any UDP packet to group 239.255.255.250
to all ports in vlan2 and forward any UDP packet to all ports in vlan3:
awplus# configure terminal
awplus(config)# int vlan2
awplus(config-if)# ip igmp flood-group 239.255.255.250 vlan3
To remove an IGMP flooding group from vlan2, use the following commands:
awplus# configure terminal
awplus(config)# int vlan2
awplus(config-if)# no ip igmp flood-group 239.255.255.250
IGMP Flooding Groups are integrated into the existing command: show ip igmp
groups
Output Figure 32-1: Example output from show ip igmp groups
Related
commands
ip igmp static-group
Command
changes
Version 5.5.0-2.3: command added
awplus#show ip igmp groups ď€
IGMP Connected Group Membershipď€
Group Address Interface Uptime Expires Last Reporterď€
239.255.255.250 vlan3000 01:20:59 stopped 0.0.0.0
To Next Page
Loading...
Need help?
General
