Allied Telesis IE340 Series - Page 1854

C613-50631-01 Rev A Command Reference for IE340 Series 1854
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
DEBUG
IPV6 PIM SPARSE-MODE TIMER
Default By default, all debugging is disabled.
Mode Privileged Exec and Global Configuration
Examples To enable debugging for the PIM-SMv6 Bootstrap Router bootstrap timer, use the
commands:
awplus(config)# debug ipv6 pim sparse-mode timer bsr bst
To enable debugging for the PIM-SMv6 Hello: neighbor liveness timer, use the
command:
awplus(config)# debug ipv6 pim sparse-mode timer hello ht
To enable debugging for the PIM-SMv6 Joinprune expiry timer, use the command:
awplus# debug ipv6 pim sparse-mode timer joinprune et
To disable debugging for the PIM-SMv6 Register timer, use the command:
awplus# no debug ipv6 pim sparse-mode timer register
Related
commands
show debugging ipv6 pim sparse-mode
kat Enable or disable debugging for the JoinPrune timer: KeepAlive Timer.
ot Enable or disable debugging for the JoinPrune timer: Upstream Override
Timer.
register Enable or disable debugging for the Register timers.
rst Enable or disable debugging for the Register timer: Register Stop Timer.
Parameter Description