C613-50631-01 Rev A Command Reference for IE340 Series 2116
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
QOS COMMANDS
EGRESS
-RATE-LIMIT
traffic is still sitting in the queues once the 200KB burst has been sent, then that
traffic will be only transmitted at 5Mbps, not at line rate. If the average egress traffic
rate is over 5Mbps, then the queues will fill up over time. When the queues become
full, the switch will drop packets and/or send pause frames to the traffic source.
You can enable the switch to send pause frames by entering the command
flowcontrol.
To disable egress rate limiting on a port, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no egress-rate-limit
Related
commands
egress-rate-limit overhead
Command
changes
Version 5.4.6-2.1: max-burst-size parameter added
To Next Page
Loading...
