C613-50631-01 Rev A Command Reference for IE340 Series 2350
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AAA COMMANDS
AAA
ACCOUNTING DOT1X
• group radius: use all RADIUS servers configured by radius-server host
command.
• group <group-name>: use the specified RADIUS server group configured
with the aaa group server command.
The accounting event to send to the RADIUS server is configured by the following
options:
• start-stop: sends a start accounting message at the beginning of a session
and a stop accounting message at the end of the session.
• stop-only: sends a stop accounting message at the end of a session.
• none: disables accounting.
Examples To enable RADIUS accounting for 802.1X-based authentication, and use all
available RADIUS Servers, use the commands:
awplus# configure terminal
awplus(config)# aaa accounting dot1x default start-stop group
radius
To disable RADIUS accounting for 802.1X-based authentication, use the
commands:
awplus# configure terminal
awplus(config)# no aaa accounting dot1x default
To enable a named RADIUS accounting method list 'vlan10_acct' for 802.1X-based
authentication, with the RADIUS server group 'rad_group_vlan10, use the
commands:
awplus# configure terminal
awplus(config)# aaa accounting dot1x vlan10_acct start-stop
group rad_group_vlan10
To disable a named RADIUS accounting method list 'vlan10_acct' for 802.1X-based
authentication, use the commands:
awplus# configure terminal
awplus(config)# no aaa accounting dot1x vlan10_acct
Related
commands
aaa accounting update
aaa authentication dot1x
aaa group server
dot1x accounting
dot1x port-control
radius-server host
show aaa server group
Command
changes
Version 5.4.9-2.1: command added to AR2050V, AR3050S, and AR4050S
To Next Page
Loading...
