Allied Telesis IE340 Series - Page 1117

C613-50631-01 Rev A Command Reference for IE340 Series 1117
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
AUTO
-COST REFERENCE BANDWIDTH
Calculation result = 0.1
Result after rounding up to the nearest integer = 1 (Interface cost is 1)
The auto-cost reference bandwidth value should be consistent across all OSPF
routers in the OSPF process.
Note that using the ip ospf cost command on a layer 3 interface will override the
cost calculated by this command.
Mode Router Configuration
Example
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# auto-cost reference-bandwidth 1000
Related
commands
ip ospf cost