C613-50631-01 Rev A Command Reference for IE340 Series 1226
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPFV3 FOR IPV6 COMMANDS
AREA
VIRTUAL-LINK AUTHENTICATION IPSEC SPI
link interfaces. Use a different SPI value for a different link interface when using
OSPFv3 with link interfaces.
OSPFv3 areas are connected to a backbone area. Virtual links can be configured to
repair lost connections to a backbone area for OSPFv3 areas. To configure an
OSPFv3 virtual link, use a router ID instead of the IPv6 prefix of the router.
Use the sha1 keyword to choose SHA-1 authentication instead of entering the
md5 keyword to use MD5 authentication. The SHA-1 algorithm is more secure
than the MD5 algorithm. SHA-1 uses a 40 hexadecimal character key instead of a
32 hexadecimal character key as used for MD5 authentication.
See the OSPFv3 Feature Overview and Configuration Guide for more information
and examples.
Example To enable MD5 authentication with a 32 hexadecimal character key for virtual links
in OPSPF area 1, use the commands:
awplus# configure terminal
awplus(config)# router ipv6 ospf
awplus(config-router)# area 1 virtual-link 10.0.0.1
authentication ipsec spi 1000 md5
1234567890ABCDEF1234567890ABCDEF
To enable SHA-1 authentication with a 40 hexadecimal character key for virtual
links in OPSPF area 1, use the commands:
awplus# configure terminal
awplus(config)# router ipv6 ospf
awplus(config-router)# area 1 virtual-link 10.0.0.1
authentication ipsec spi 1000 sha1
1234567890ABCDEF1234567890ABCDEF12345678
To disable authentication for virtual links in OPSPF area 1, use the commands:
awplus# configure terminal
awplus(config)# router ipv6 ospf
awplus(config-router)# no area 1 virtual-link ipsec spi 1000
Related
commands
area authentication ipsec spi
area encryption ipsec spi esp
area virtual-link encryption ipsec spi
show ipv6 ospf virtual-links
To Next Page
Loading...
Need help?
General
