C613-50631-01 Rev A Command Reference for IE340 Series 157
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
CRYPTO
VERIFY
Default No default
Mode Global Configuration
Usage notes All models of a particular series run the same firmware file and therefore have the
same checksum for that firmware file. For example, all x930 Series switches have
the same checksum.
If your network has extremely strict security requirements, such as FIPS
compliance, you may need to verify the bootloader on boot-up and use signature
verification for the firmware file. To configure these, use the commands crypto
verify bootrom and crypto verify signed. These commands make it difficult to
upgrade the bootloader or firmware, so only use them if necessary.
Examples To verify the firmware file for 5.5.3-0.1 on an x930 Series switch, use the commands:
awplus# configure terminal
awplus(config)# crypto verify x930-5.5.3-0.1.rel
7f22d8a30c991a4ddc0a2aed47246282b23b4e4a865e07f79795c0959c47de
78
Related
commands
crypto secure-mode
crypto verify bootrom
crypto verify signed
show hash
show secure-mode
Command
changes
Version 5.5.3-0.1: gui parameter added; <filename> parameter expanded to cover
all file types
To Next Page
Loading...
Need help?
General
