EasyManua.ls Logo

Allied Telesis IE340 Series - Page 1986

Allied Telesis IE340 Series
3474 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C613-50631-01 Rev A Command Reference for IE340 Series 1986
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(NAMED HARDWARE ACL ENTRY FOR IP PROTOCOLS)
Mode IPv4 Hardware ACL Configuration (accessed by running the command access-list
hardware (named hardware ACL))
Default On an interface controlled by a hardware ACL, any traffic that does not explicitly
match a filter is permitted.
Usage notes To use this command, run the command access-list hardware (named hardware
ACL) and enter the desired access-list name. This changes the prompt to:
awplus(config-ip-hw-acl)#
Then use this command (and the other “named hardware ACL: entry” commands)
to add filter entries. You can add multiple filter entries to an ACL. You can insert a
new filter entry into the middle of an existing list by specifying the appropriate
sequence number. If you do not specify a sequence number, the switch puts the
entry at the end of the ACL and assigns it the next available multiple of 4 as its
sequence number.
Then use the access-group or the match access-group command to apply this ACL
to a port, VLAN or QoS class-map. Note that the ACL will only apply to incoming
data packets.
Examples To add a filter entry to the access-list named “my-list” that will deny all IGMP
packets (protocol 2) from the 192.168.0.0 subnet, and give it a sequence number
of 50, use the commands:
awplus# configure terminal
awplus(config)# access-list hardware my-list
awplus(config-ip-hw-acl)# 50 deny proto 2 192.168.0.0/16 any
Related
commands
access-group
access-list hardware (named hardware ACL)
match access-group
show running-config
show access-list (IPv4 Hardware ACLs)
Command
changes
Version 5.5.3-0.1: deny-and-not-cpu action parameter added on x230, x550, x930,
x950, SBx908 GEN2 Series switches
137 MPLS-in-IP / RFC4023
138 MANET Protocols / RFC-ietf-manet-iana-07.txt
139-252 Unassigned / IANA
253 Use for experimentation and testing / RFC3692
254 Use for experimentation and testing / RFC3692
255 Reserved / IANA
Table 38-6: IP protocol number and description (cont.)
Protocol Number Protocol Description [RFC]

Table of Contents

Other manuals for Allied Telesis IE340 Series

Related product manuals