C613-50631-01 Rev A Command Reference for IE340 Series 1994
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV4 HARDWARE ACCESS CONTROL LIST (ACL) COMMANDS
(NAMED HARDWARE ACL ENTRY FOR TCP OR UDP)
entry at the end of the ACL and assigns it the next available multiple of 4 as its
sequence number.
Then use the access-group or the match access-group command to apply this ACL
to a port, VLAN or QoS class-map. Note that the ACL will only apply to incoming
data packets.
Example To add a filter entry to access-list named “my-list” that will permit TCP packets with
a destination address of 192.168.1.1, a destination port of 80, from any source, use
the commands:
awplus# configure terminal
awplus(config)# access-list hardware my-list
awplus(config-ip-hw-acl)# permit tcp any 192.168.1.1/32 eq 80
Related
commands
access-group
access-list hardware (named hardware ACL)
match access-group
show running-config
show access-list (IPv4 Hardware ACLs)
Command
changes
Version 5.5.3-0.1: deny-and-not-cpu action parameter added on x230, x550, x930,
x950, SBx908 GEN2 Series switches
Version 5.5.3-0.1: log parameter added on x220, x320, x530, x550, x950, SBx908
GEN2 Series switches
Version 5.4.7-2.1: send-to-vlan-port action parameter added on GS900MX,
GS980MX, XS900MX, SBx8100, SBx908 GEN2, x950 Series switches
Version 5.4.6-2.1: send-to-vlan-port action parameter added on IX5, x230, x310,
x510, x930 Series switches
To Next Page
Loading...
Need help?
General
