C613-50631-01 Rev A Command Reference for IE340 Series 2046
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
SHOW
DOS INTERFACE
Figure 39-2: Example output from the show dos interface command after a
synflood DoS attack
awplus#show dos interface port1.0.1ď€
ď€
DoS settings for interface port1.0.1ď€
-----------------------------------------ď€
Port status : Enabledď€
ipoptions : Disabledď€
land : Disabledď€
ping-of-death : Disabledď€
smurf : Disabledď€
synflood : Enabledď€
Action : Shutdown portď€
Attacks detected : 1ď€
teardrop : Disabledď€
awplus#ď€
Table 40: Parameters in the show dos interface command output:
Type of DoS attack Description
Port status Displays Enabled when the port is configured as being
administratively up after issuing the no shutdown command.
Displays Disabled when the port is configured as being
administratively down with the shutdown command.
ipoptions Displays Enabled when the ipoptions parameter is
configured with the dos command, plus the action (Shutdown
port, Mirror port, or Trap port) and the number of
instances of any ipoptions DoS attacks that have occurred on
the interface.
Displays Disabled when the ipoptions parameter is not
configured with the dos command.
land Displays Enabled when the land parameter is configured
with the dos command, plus the action (Shutdown port,
Mirror port, or Trap port) and the number of instances
of any land DoS attacks that have occurred on the interface.
Displays Disabled when the land parameter is not
configured with the dos command.
ping-of-death Displays Enabled when the ping-of-death parameter is
configured with the dos command, plus the action (Shutdown
port, Mirror port, or Trap port) and the number of
instances of any ping-of-death DoS attacks that have occurred
on the interface.
Displays Disabled when the ping-of-death parameter is not
configured with the dos command.