Allied Telesis IE340 Series - Page 2119

C613-50631-01 Rev A Command Reference for IE340 Series 2119
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
QOS COMMANDS
MATCH
ACCESS-GROUP
To configure a class-map named “cmap3”, which matches traffic against access-list
“hw_acl”, which allows IP traffic from any source to any destination, use the
commands:
awplus# configure terminal
awplus(config)# access-list hardware hw_acl
awplus(config-ip-hw-acl)# permit ip any any
awplus(config)# class-map cmap3
awplus(config-cmap)# match access-group hw_acl
To apply ACL 3001 to VLAN 48, where the ACL drops IP traffic from any source to
any destination, use the commands:
awplus# configure terminal
awplus(config)# access-list 3001 deny ip any any
awplus(config)# vlan access-map deny_all
awplus(config-vlan-access-map)# match access-group 3001
awplus(config-vlan-access-map)# exit
awplus(config)# vlan filter deny_all vlan-list 48 input
Related
commands
class-map
vlan access-map
Command
changes
Version 5.4.6-2.1: support for VLAN access-maps added