C613-50631-01 Rev A Command Reference for IE340 Series 2161
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
QOS COMMANDS
SHOW
PLATFORM CLASSIFIER STATISTICS UTILIZATION BRIEF
Related
commands
show platform
ipv6 access-list (named IPv6 hardware ACL)
DHCP Snooping Entries used to send DHCP and ARP packets to the CPU. User-added DHCP
Snooping filters under ACLs are counted under the ACL or QoS categories.
Loop Detection Entries uses to send the special loop detection frame to the CPU.
EPSR Entries used to send EPSR control traffic to the CPU.
CFM Entries used by Connectivity Fault Management.
G8032 Entries used to send G.8032 control traffic to the CPU.
Global ACLs Entries for ACLs appear here if the ACLs are applied globally instead of per
switchport.
ACL Entries for ACL filters that have been applied directly to ports using the
access-group command.
VACL Entries for VLAN-based ACLs (ACLs that are applied to VLANs instead of ports).
DOS Entries used for Denial of Service protection.
UFO Entries used by Upward Forwarding Only (UFO).
QoS Entries for ACL filters and other class-map configurations, such as policers, applied
through policy maps using the service input command.
RA Guard Entries used to block IPv6 router advertisements, configured with the ipv6 nd
raguard command.
AMFAPPS Entries used by AMF Application Proxy. These entries enable the SES Controller to
block infected ports.
Pre-Ingress Entries used for VLAN ID Translation (and also for subnet-based and MAC-based
VLAN entries on SBx81XLEM cards).
Egress Entries used for VLAN ID Translation.
UDB User Defined Bytes (UDB), which are a limited resource of bytes that can be used to
implement additional arbitrary matching on packet bytes on some switches. The
software manages the use and allocation of these bytes automatically. The output
of this table is intended for use by Allied Telesis Customer Support only.
Parameter Description
To Next Page
Loading...
Need help?
General
