C613-50631-01 Rev A Command Reference for IE340 Series 2213
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
AUTH-FAIL VLAN
as a supplicant on the Guest VLAN. For more information about ACL concepts, and
configuring ACLs see the ACL Feature Overview and Configuration Guide. For
more information about ACL commands see:
• IPv4 Hardware Access Control List (ACL) Commands
• IPv4 Software Access Control List (ACL) Commands
• IPv6 Hardware Access Control List (ACL) Commands
• IPv6 Software Access Control List (ACL) Commands
Examples To enable the auth-fail vlan feature for port1.0.2 and assign VLAN 100, use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth auth-fail vlan 100
To disable the auth-fail vlan feature for port1.0.2, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth auth-fail vlan
Related
commands
auth profile (global)
dot1x max-auth-fail
show dot1x
show dot1x interface
show running-config
Command
changes
Version 5.4.9-2.1: command added to AR2050V, AR3050S, and AR4050S
To Next Page
Loading...
Need help?
General
