C613-50631-01 Rev A Command Reference for IE340 Series 2729
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
G.8032 ETHERNET RING PROTECTION SWITCHING COMMANDS
SHOW
G8032 ERP-INSTANCE
CFM MEP East or
West
Identifies the configured MEP, if any, that is being used to
provide a CFM based Signal Fail indication to this instance.
The MEP is identified by its direction (Up or Down), its
MEP-id, and the Maintenance Domain (MD) and
Maintenance Association (MA) it is associated with by
name.
ERP Profile Identifies the ERP Profile instance that was configured for
use by this ERP Ring instance.
Level The Level that was configured for R-APS messages that are
used by this ERP Ring instance.
Ring-ID The Ring-ID that is to be used by this ERP instance.
RAPS-Channel VLAN The VLAN-id that is configured used for sending and
receiving R-APS messages for this ERP instance.
Sub-ring Specifies whether the ring is operating as a Sub-ring or
otherwise as a Major ring.
Virtual Channel Specifies whether the sub-ring is operating with a virtual
channel or not.
Data Traffic VLANs A comma-separated list of configured VLAN-ids
(individually, or range) that are used for data-traffic and
protected by this ERP instance.
TCN To Inst A comma-separated list of protocols and their instances
that are to be notified when a Topology Change
Notification occurs for this ERP instance. This only applies
to a sub-ring with a Terminating interface and in which
case "-" will be displayed if no target instances have been
identified. Otherwise a "-" is displayed anyway.Identifies
the protocol to notify. Only "G8032" will be supported
initially.<instance-name> - Identifies the instance to notify
for the given protocol.
TCN Flush Event Specifies if this instance as a target instance is to send out
Flush FDB messages upon TCN notifications by a
detecting instance.Identifies the notifying protocol
allowed. Only "G8032" will be supported initially. If no
protocols have been configured then display "-".
SNMP Traps Indicates whether SNMP traps have been enabled or
disabled for this ERP instance.
Table 1: Parameters in the output from the show g8032 erp-instance
command. (cont.)
Parameter Description
To Next Page
Loading...
Need help?
General
