Allied Telesis IE340 Series - Page 2867

C613-50631-01 Rev A Command Reference for IE340 Series 2867
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
SECURE-MODE ENABLE-ALL
• Runs a script which executes atmf secure-mode and then writes the
configuration file on each node.
• Starts a timer that ticks every 10 seconds, for a maximum of 10 times, and
checks if all the secure mode capable nodes rejoin the AMF network.
Running no atmf secure-mode enable-all:
• Groups all AMF nodes in a working set.
• Runs a script which executes no atmf secure-mode and then writes the
configuration file on each node.
• Starts a timer that ticks every 10 seconds, for a maximum of 10 times, and
checks if all the secure mode capable nodes rejoin the AMF network.
NOTE: Enabling or disabling secure mode on the network saves the running-config on
every device.
Example To enable AMF secure mode on the entire network, use the command:
awplus# atmf secure-mode enable-all
You will be prompted to confirm the action:
To disable AMF secure mode on the entire network, use the command:
awplus# no atmf secure-mode enable-all
You will be prompted to confirm the action:
Related
commands
aaa authentication auth-web
show atmf
Command
changes
Version 5.4.7-0.3: command added
Total number of nodes 21
21 nodes support secure-mode

Enable secure-mode across the AMF network ? (y/n): y
% Warning: All security certificates will be deleted.
Disable secure-mode across the AMF network ? (y/n): y