Allied Telesis IE340 Series - Page 2892

C613-50631-01 Rev A Command Reference for IE340 Series 2892
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
CLONE
(AMF-PROVISION)
To confirm that a new provisioned node has been cloned, use the command:
device1# show atmf backup
The output from this command is shown in the following figure, and shows the
details of the new provisioned node ‘device3’.
Figure 57-5: Sample output from the show atmf backup command
Related
commands
atmf provision (interface)
atmf provision node
configure boot config (amf-provision)
configure boot system (amf-provision)
copy (amf-provision)
create (amf-provision)
delete (amf-provision)
identity (amf-provision)
license-cert (amf-provision)
locate (amf-provision)
show atmf provision nodes
Command
changes
Version 5.4.9-0.1: syntax change due to new AMF provisioning mode
device1#show atmf backup 

Scheduled Backup ...... Enabled
Schedule ............ 1 per day starting at 03:00
Next Backup Time .... 01 Oct 2018 03:00
Backup Bandwidth ...... Unlimited
Backup Media .......... USB (Total 7446.0MB, Free 7297.0MB)
Server Config ......... 
Synchronization ..... Unsynchronized
Last Run .......... -
1 .................. Unconfigured
2 .................. Unconfigured
Current Action ........ Idle
Started ............. -
Current Node ........ -

---------------------------------------------------------------
Node Name Date Time In ATMF On Media Status 
---------------------------------------------------------------
device3 - - No Yes Prov 
device1 30 Sep 2018 00:05:49 No Yes Good 
device2 30 Sep 2018 00:05:44 Yes Yes Good