C613-50631-01 Rev A Command Reference for IE340 Series 2995
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF NODES
To display AMF information for all nodes, including guest nodes, use the
command:
node1# show atmf nodes all
To display AMF information for guest nodes only, use the command:
node1# show atmf nodes guest
Related
commands
show atmf
show atmf area nodes
discovery
http-enable
show atmf backup guest
Table 58: Sample output from show atmf nodes all. In this example, not all nodes support node map
exchange, as shown by the message at the end
node1#show atmf nodes all
Node and Guest Information:
* = Local device
SC = Switch Configuration:
C = Chassis S = Stackable N = Standalone G = Guest
Node/Guest Device ATMF Parent Node
Name Type Master SC Domain Depth
--------------------------------------------------------------------------------
* M1 x510-28GTX Y S none 0
N3 x230-18GP N N M1 1
N1 AR4050S N N M1 1
N3-1.0.24 AT-TQ4600 N G N3 -
Node map exchange is inactive
Firmware on some nodes does not support node map exchange, eg AR4050S
Current ATMF node count 4 (guests 1)
Table 57-1: Sample output from show atmf nodes guest
node1#show atmf nodes guest
Guest Information:
Device MAC IP/IPv6
Name Address Parent Port Address
--------------------------------------------------------------------------------
aastra-... 0008.5d10.7635 Node-1 1.0.2 192.168.4.7
poe-1.0.1 0013.1a1e.4589 Node-1 1.0.1 192.168.4.6
ip-camera 0800.239e.f1fe Node-1 1.0.4 192.168.4.8
tq4600 eccd.6df2.da60 Node-1 1.0.5 192.168.4.50
To Next Page
Loading...
